To help you in doing your laminate flooring in the room, the following guidelines may be you can use.
First: Examination of Power and Ground Floor flatness.
Floor space will be paired wood flooring laminate flooring must first dichek strength and flatness of the floor. The ground floor is made of cement must be ensured there is no grain or scrap pile so that it will complicate the cement flooring laminate flooring. If there is a floor that is considered less strong immediate improvement.
Second: adjustment of room.
Laminate floor is very sensitive to temperature and humidity conditions which can affect the floor boards. Wood flooring laminate floor should be done adjusting the temperature and humidity of the room in the house at least 48 hours before installation. Temperature adjustment and inertia can be done by placing the laminate flooring is flat on the floor of the room to be installed. Before it is placed on the floor all laminate sheets of plastic wrap on floring must first be opened. Sheet is placed at least not mutually bertindih, but at least it should be provided work space to cut and install.
Third: Clean the surface of the ground floor.
The ground floor should be cleaned of all dirt and oils from the surface of the ground floor. Before the installation must be ensured in the dry state.
Fourth: Installation of vapor barrier Gazette.
Before pairing sheets of wood laminate flooring, latai must first be covered with a sheet that can mengahalangi direct evaporation from the wood floor. To the first floor is covered with a sheet of aluminum foil or a similar kind of other plastic sheets. This sheet should cover each other so that evaporation can not really directly connected to the wood laminate flooring.
Fifth: Setting the elevation above the surface of the wood under the door.
For a room that has a door, it must first be determined on the surface elevation setting of the laminate flooring to be installed. Elevation above should really be set as possible so that the door can move freely when opened and closed and did not have a big enough gap to the wooden floor was installed. Follow elevations in this setting to the rest room there, and do a guide to making yarn surface elevation height of the room.
Sixth: Installation of the First Statute.
For best viewing, place a sheet of laminate flooring board terpanjang.Pasang sheets parallel to the wall first with a groove to the wall. Place the sheet with a distance of about 1 cm from the wall and then slide the board toward the wall. This space is intended to get the space next shift if the condition of the wall sheets are not aligned so that at the end of the next shift is still easy to get the flatness of the wall. You can set spaser (waveguide spacing) at a distance of the next sheet.
Seventh: Installation Next Sheet.
For the installation of the next sheet you have prepared sebelumnay tongue connection to the next sheet. It is intended that the sheet of laminate flooring board is not too easy to shift. And it is believed will make the bond stronger anntar sheet. Do the manufacture of the tongue that is not too difficult for the next connection. Also making the connection of the tongue will make the connection is not too monotonous, so the floor will look more beautiful.
Eight: Installation The Last Sheet.
Installation of last sheet would be affected from lembarabn mouthpiece of the previous sheet. Make sure you follow the exact size of the last remaining space, so there is no connection there are gaps between the sheets of laminate flooring.
Ninth: Lock Installation Sheet.
Installation sheet made to lock the outer edge of the sheet so as to make the floor more presentable.
 |
| Good Floor |
No comments:
Post a Comment